Sawmill and Timber
Everything else! => Off the Topic! => Topic started by: lauztuvass on December 10, 2015, 11:42:03 AM
-
Hi, I was trying to find a good place for my topic. Not sure - it is good or not. Here to post.
So i have 4 head planer. Every head have a motor 2.2kw and 2700rmp. Head is turning abuoth 3600 speed. Head diameter abouth 120mm. 4 knifes in one. Cuting deep- from zero to 5mm ( my bords is not lig). Bords ( which i want to play in planer) is 120mmm X 30mm.
Abuoth 5 years ago i was fuonded in web some calculators for this. But yesterday and today i tryed- no succed.
Sorry if my topic in wrong place.
-
I'd think that feed speed would depend on what kind of finish you want on the wood. My Woodmaster has a variable speed adjustment. Faster feed speed gives a rougher finish (but it's faster), slower speed gives gives a finer finish. It gets down to cuts per cm of wood going through. Are you planing construction lumber or furniture wood?
Oh, "Abuoth" = "About" in American.
-
Sorry, my bad language.
My wood wil be for furniture. So I want better quality.