alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description
« previous next »
Pages: 1 [2]  All   Go Down

Author Topic: Can you crosscut with a bandsaw mill  (Read 29700 times)

Offline HaroldCR - AKA Fla.-Deadheader

  • Old Timers Club
  • *****
  • Posts: 1017
Re: Can you crosscut with a bandsaw mill
« Reply #25 on: August 30, 2013, 11:05:15 PM »

 Been very busy the past few days, preparing for a 2 week trip to Florida. I will try to get some sketches put together on Sunday and post them to your email address.
Logged

Offline HaroldCR - AKA Fla.-Deadheader

  • Old Timers Club
  • *****
  • Posts: 1017
Re: Can you crosscut with a bandsaw mill
« Reply #26 on: September 01, 2013, 02:47:23 PM »

 bbergami---email sent.
Logged

Offline HaroldCR - AKA Fla.-Deadheader

  • Old Timers Club
  • *****
  • Posts: 1017
Re: Can you crosscut with a bandsaw mill
« Reply #27 on: September 23, 2013, 05:46:01 AM »

 OK. Back online thanks to Kirk.  ;D ;D
Logged

Offline bbergami

  • New Contributor
  • *
  • Posts: 13
Re: Can you crosscut with a bandsaw mill
« Reply #28 on: September 23, 2013, 10:24:17 AM »
Harold, got the pictures. They are very helpful. Thanks. Basically the screw will do all the clamping, correct? The hyd cylinder will adjust the height of the clamp point and help roll the log.
Logged

Offline HaroldCR - AKA Fla.-Deadheader

  • Old Timers Club
  • *****
  • Posts: 1017
Re: Can you crosscut with a bandsaw mill
« Reply #29 on: September 23, 2013, 11:57:34 AM »

 Very astute observations.  ;D ;D :laugh: :laugh:  Any other questions, just ask, here or PM.
Logged
Pages: 1 [2]  All   Go Up
« previous next »