alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description
« previous next »
Pages: [1]   Go Down

Author Topic: Cooks toothe setter  (Read 7306 times)

Offline backwoods sawyer

  • Major Contributor
  • ***
  • Posts: 151
Cooks toothe setter
« on: August 13, 2015, 08:18:54 PM »
The tooth setter developed a clunk so I pulled it apart and replaced a broken bolt that holds the bushing/bearing
While I had it apart I found two were bearings and one was a brass bushing and the other a harder bushing.
Since several on here use the same tooth setter I was wondering if yours runs bearings or bushings. The brass was a bit soft and was being eroded by the bolt that rides on it.
Logged

Offline furu

  • Senior Contributor
  • ****
  • Posts: 668
Re: Cooks toothe setter
« Reply #1 on: August 17, 2015, 12:54:59 AM »
Don't know.  I have never had mine apart.  Will have to take a look?

If my memory is correct you might have a problem getting a straight answer from manufacturer.  Just don't tell them who you are when you call?
Logged
Integrity is not just doing the right thing.
Integrity is not just doing the right thing when no one is looking.
Integrity is doing the right thing when no one else will ever even know.
Pages: [1]   Go Up
« previous next »