alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description alt image description

Author Topic: Abuoth 4 head planer feed speed  (Read 10097 times)

Offline lauztuvass

  • Contributor
  • **
  • Posts: 59
  • Topics: 4
  • Referrals: 0
Abuoth 4 head planer feed speed
« on: December 10, 2015, 11:42:03 AM »
Hi, I was trying to find a good place for my topic. Not sure - it is good or not. Here to post.
So i have 4 head planer. Every head have a motor 2.2kw and 2700rmp. Head is turning abuoth 3600 speed. Head diameter abouth 120mm. 4 knifes in one. Cuting deep- from zero to 5mm ( my bords is not lig). Bords ( which i want to play in planer) is 120mmm X  30mm.
Abuoth 5 years ago i was fuonded in web some calculators for this. But  yesterday and today i tryed- no succed.
Sorry if my topic in wrong place.

Offline Stevem

  • Old Timers Club
  • *****
  • Posts: 1106
  • Topics: 100
  • Referrals: 1
Re: Abuoth 4 head planer feed speed
« Reply #1 on: December 12, 2015, 10:49:36 AM »
I'd think that feed speed would depend on what kind of finish you want on the wood. My Woodmaster has a variable speed adjustment.  Faster feed speed gives a rougher finish (but it's faster), slower speed gives gives a finer finish.  It gets down to cuts per cm of wood going through.  Are you planing construction lumber or furniture wood?

Oh, "Abuoth" = "About" in American.
« Last Edit: December 12, 2015, 11:01:07 AM by Stevem »
Stevem
Because you can doesn't mean you should!

Offline lauztuvass

  • Contributor
  • **
  • Posts: 59
  • Topics: 4
  • Referrals: 0
Re: Abuoth 4 head planer feed speed
« Reply #2 on: December 12, 2015, 12:41:03 PM »
Sorry, my bad language.
My wood wil be for furniture. So I want better quality.