Sawmill and Timber
Sawmills and Sawing => Bandsaw Mills => Topic started by: Plowboy on July 25, 2015, 07:10:05 PM
-
Hi Folks
I just bought a Canadian Board Master sawmill from an estate auction. It has not been used for at least 7 years. Everything is seized. There is an electric 12V motor to raise the blade> I t has a wire that is not connected to anything and I cannot see where it should be connected. There must be a switch somewhere that controls the motor. Anyone know anything about Canadian Boradmaster saws or where the wire should be connected.
Thanks
-
Just guessing , I think you need a reversing drum switch like WM uses rated for high amps or it could be set up with some solenoids using a lower amp toggle switch. Those DC motors change the polarity to reverse the motor. Steve